User's Manual

SDRe Programming Software
Revision V1.0
P a g e | 74
Figure 96: Repeater write confirmation screen
Repeater will do a power cycle to load the new parameters after a read
or write process.
8. Repeater Alignment
Refer to Service manual for alignment procedure.
9. Repeater factory Reset
In case the repeater has been realigned by somebody who does not
understand the procedure correctly or any other problem, which may
affect to the repeater performance, you can reset as per initial factory
settings.
This process will erase all the information on your repeater, which
cannot be recovered except from backup on computer files.
To proceed to reset the repeater as per factory default, please click on
[Repeater] then [Factory Reset]
Attempting to upload to a radio will fail if the information generated with the programming software is
not for such radio model.
Note: 14- Model mismatch reports uploading error.