User's Manual

SDRe Programming Software
Revision V1.0
P a g e | 38
Figure 31: Sample of MAC Address input
4.3.2.2. Ethernet Speed:
Depending of the media quality and the possibilities of you link,
you can select the speed for the IP port.
Press on the side arrow to slide the menu down then select you
desired option:
Figure 32: IP port speed and mode selection
AUTO: The repeater will negotiate the most convenient
operational speed and mode in agree to the possibilities of your
network.
Evenly when this selection is convenient, the success of this
depends of the stability of your network because negotiation
takes some time. In case it must be negotiated very often, it will
be not convenient.
100Mbps Full: the PHY port will operate at 100 Mbps full duplex
(RX and TX at the time).
100Mbps Half: the PHY port will operate at 100 Mbps semi
duplex (never RX and TX at the same time).
10Mbps Full: the PHY port will operate at 10 Mbps full duplex
(RX and TX at the time).
10Mbps Half: the PHY port will operate at 10 Mbps semi duplex
(never RX and TX at the same time).