User's Manual

SDRe Programming Software
Revision V1.0
P a g e | 28
4.2.2.4. Power Up:
Assign this command to change the RF output power selection.
This command will jump from Low Power to Mid Power, from Mid
Power to High Power, from High Power to Low Power, depending
on the current power selection.
The absolute power assigned to each power selection must be
aligned as per Alignment section descripted on Service manual.
4.2.2.5. Power Down
Assign this command to scroll the RF output power selection.
This command will jump from High Power to Mid Power, from Mid
Power to Low Power, from Low Power to High Power, depending
on the current power selection.
The absolute power assigned to each power selection must be
aligned as per Alignment section descripted on Service manual.
4.2.2.6. Display Toggle
Commonly, the display backlight goes to power off mode after 10
seconds. If you want to let it continuously on by 12 hours, assign
this function to one button then you can toggle between power
save backlight mode and long term backlight on. This function is
useful for in-site maintenance or inspection.
4.2.2.7. Monitor
Assign this command to open the audio path without any
signaling or carrier level consideration.
This command only operates on analog and hybrid mode.
As this function does not care about any signaling, if you assign it to some button, then you
may know that the system privacy may be affected when this function is active
Note: 6 - Monitor privacy warning for a fleet