User's Manual

Page 46
APPENDIX II : SELECTIVE CALLS
Some radio mode supports selective calling (Analog MDC, digital TDMA
or Digital FDMA). By this reason, your radio has an associated ID.
If your radio has been programmed with this feature, you will see your
ID into the display notification area.
In case you see only one ID into this area, then it means your radio is in
all-call mode, which means your transmission will be received by all your
partners each time you press the PTT.
If you wish to make a selective call, then you have two options:
A – Type the destination ID from the Keyboard then press [OK]
B – Select the destination ID from radio’s phone book then press [OK]
Any of the modes you choose, lets you address all your transmission to
only one user. Destination ID could be also a group ID.
After you select an ID, you can see the destination of your transmissions
into the display’s notification area (for example 1001/1002).
In case your destination ID is on your phone book, you can read the
contact name into display’s notification area (for example 1002/Emily).
To receive a selective call, a destination radio must have the selective call
enabled.
If so, only the enabled radio will receive each one of your transmissions
when you press the PTT under a selective call mode.