Specifications

B – Sit-on t
A – Flush t
Installer
Please leave this leaet with the user, as it contains valuable
after care advice.
Notes

Please take care of sharp metal edges before and
during installation.

During installation, take care to protect the sink
from scus and scratches.

Avoid straining and overtightening of all plumbing
xtures connected to the sink.

Carefully check that the moulding and edges of the
sink are dead level so that water will ow o the
drainer.

We recommend that the worktop opening is sealed
using waterproof sealant, paint or a similar material.
Fig.1
Due to our policy of continual improvement, we reserve the right to change specications without prior notice.
INSTALLATION

The clamping brackets are suitable for worktops of
greater than 36 mm thickness. If your worktop is a
dierent size then it may require packing under the
clips or rebating.

If ush mounting the sink, we strongly recommend
that this is carried out by a suitably skilled
tradesperson.

We recommend that you t the inset sink to the
worktop before permanently xing the worktop to
the cabinet.

When tting a tap, we recommend you use a tap
stabiliser bracket to ensure a secure t.
Installation
There are two tting options (Fig.1): ush mount and sit-on
t.