SENATOR STAINLESS STEEL INSET SINK WITH FIXED POSITION CLIPS Installation Instructions & Aftercare Information 3966-03
INSTALLATION Installer Please leave this leaflet with the user, as it contains valuable after care advice. Notes Please take care of sharp metal edges before and nn during installation. During installation, take care to protect the sink nn from scuffs and scratches. Avoid straining and overtightening of all plumbing fixtures connected to the sink. nn Carefully check that the moulding and edges of the nn sink are dead level so that water will flow off the drainer.
Flush Mount 1. 2. 3. 4. 5. Using a soft, sharp pencil, mark out the sink top opening dimensions onto the worktop. Draw another line 6 mm inside the sink top outline – this is the cutting line for the opening (Fig.2). Drill as large a hole as possible inside the cutting line. Using a router, padsaw, jigsaw or similar, cut out the opening up to the cutting line. Outer edge for rebate Fig.3 Rebate the worktop up to the outer line (Fig.3). 7. 8. 9.
Sit-on Fit Fig.6 1. Place the sink upside down on the worktop. Position the sink on the worktop as required. Make sure the cabinet framework will clear all parts of the sink. Using a soft, sharp pencil draw around the sink as accurately as possible (Fig.6). Remove the sink. Alternatively, you can use a sink template. For details go to www.rangemaster.co.uk. 2. Fig.7 Worktop 3. 4. Cutting line for opening 6 mm 5. 6. Sink outline 7. Fig.
Fitting the Overflow Pipework Fig.10 The overflow pipework for the sink will require modifying to fit. Cut the part as shown (Fig.10). Fit the overflow pipework together as normal. To provide a watertight seal, apply silicon sealant onto the sink-side face of the rubber seal before fitting it to the sink (Fig.11). 27 mm 110 mm Rubber seal Fig.
Technical Data Senator 1.5 Bowl Sink Sink edge thickness 1.2 nominal 180+20 340+20 220+20 +2 0 972±0.
Senator 1.0 Bowl Sink Sink edge thickness 1.2 nominal 500+20 220+20 +2 0 972±0.
AFTER CARE Day-to-day Care Routine cleaning of your stainless steel sink is easy if the following simple procedure is followed: After use wipe the bowl and drainer with a soft damp soapy cloth and rinse with clean water. In hard water areas, an application of proprietary cream cleaner or stainless steel sink cleaner will avoid any build-up of a dull film of waterborne deposits.
