Operating Instructions and Installation Instructions
15
Spray Arms
Limescale and remnants of food in the washing water can
block the nozzles in the spray arms and the arm mountings.
Inspect the nozzles in the spray arms for blocked holes due to
remnants of food.
If necessary, pull the lower arm (Fig.3-6) upwards and lift it
o. Unscrew the upper spray arm (Fig.3-7).
Clean both spray arms under running water.
Ret the spray arms. Make sure that the lower arm
has locked into place and the upper one is screwed
tight.
Solvents or Abrasive Cleaning Products
To clean the exterior and rubber parts of the dishwasher, do
not use solvents or abrasive cleaning products. Rather, use
only a cloth and warm soapy water.
To remove spots or stains from the surface of the interior, use
a cloth dampened with water and a little white vinegar or a
cleaning product made specically for dishwashers.
Moving the Dishwasher
If the dishwasher must be moved, try to keep it in a vertical
position. If absolutely necessary, it can be positioned on its
back.
Seals
One of the factors that cause odours to form in the
dishwasher is food that remains trapped in the seals. Periodic
cleaning with a damp cloth will prevent this from occurring.
Hose Filter
To prevent particles of rust, sand etc. entering your
dishwasher the inlet hose is tted with a lter. To clean the
lter, turn o the water tap and unscrew the hose. After
cleaning insert the lter into the hose. Ret the hose and turn
the water tap on.
When You Go on Holiday
When you go on holiday, it is recommended that you run a
wash cycle with the dishwasher empty and isolate from the
mains. Turn o the water supply and leave the door of the
dishwasher slightly ajar. This will help the seals last longer and
prevent odours from forming within the dishwasher.
Fig.3-6
Fig.3-7
Fig.3-5