Operating Instructions and Installation Instructions

14
Low salt indicator
12
11
Care
After Every Wash
After every wash, set the ON-OFF button to OFF and leave the
door slightly ajar so that moisture and odours are not trapped
inside.

Before cleaning or performing maintenance isolate
from mains.
Overall Condition of the Dishwasher
Check that no grease or scale has accumulated on the inside
of the dishwasher. If you discover any deposits: Clean the
interior of the dishwasher thoroughly with a detergent
solution.
Dishwasher Salt
Check the LOW SALT indicator (Fig.3-1). If required, top up
with salt .
Rinse Aid
Check the low rinse indicator (Fig.3-2) on the control panel. If
required, top up with rinse aid.
Filters
The lters prevent larger particles of food in the water from
reaching the pump. These particles may occasionally block
the lters.
When the dishwasher has nished washing, check the lters
for particles of food and, if required, clean.
After removal (Fig.3-3), the course and micro lter unit can
be separated (Fig.3-4). Remove any particles of food and
rinse the lters under running water.
With the course and micro lters removed, the base lter can
be removed. Lift at the front and pull clear (Fig.3-5).
Once cleaned, replace the lters. Tighten the course and
micro lters by turning counter clockwise.

Never use the dishwasher without the lters tted.
3. Looking after your Dishwasher
Fig.3-1
Fig.3-3
Fig.3-4
Low rinse aid indicator
Fig.3-2