Operating Instructions and Installation Instructions
11
Switching the Dishwasher OFF
Several minutes after the program has ended:
1. Open the door.
2. Set the ON-OFF button to OFF.
3. Remove dishes, etc. when they have cooled down.
Note: For the best drying performance, we recommend that
you do not remove the contents for at least 30 minutes. This
allows residual heat in the dishwasher to remove any small
droplets of water that may occur.
Interrupting the Program
CAUTION!
There is a risk of water coming out from inside the
dishwasher. DO NOT open the door fully until the
spray arm has stopped rotating.
If the dishwasher has already heated up or the hot water was
switched ON and then the dishwasher door opened, leave the
door ajar for several minutes and then close.
After 30 seconds the program will start from the point it was
interrupted. If the door is opened during the drying process
the program will be terminated.
Cancelling a Program
CAUTION!
There is a risk of water coming out from inside the
dishwasher. DO NOT open the door fully until the
spray arm has stopped rotating.
To cancel a program that is underway, carefully open
the door and press the program button and hold it in for
about 3 seconds. When the door is closed the water will be
discharged for about thirty seconds. Five beeps will indicate
that the program is cancelled; the end of program indicator
will turn on.
Modifying a Program
CAUTION!
There is a risk of water coming out from inside the
dishwasher. DO NOT open the door fully until the
spray arm has stopped rotating.
A cycle that is underway can be modied if it has only been
running for a short time. Otherwise, the detergent may have
already been used and the dishwasher may have already
drained the wash water. If this is the case, the detergent
dispenser must be relled (see ‘Loading the detergent’).
To modify a cycle that is already underway, open the door
and select a new program by pressing the program selection
button. Closing the door will start the new program from a
suitable point in the old program.