User's Guide
Table Of Contents
- U110689 Cover
- U110689-03a [GB]
- 1. Before you start...
- 2. Cooker Overview
- 3. 2 Button - rotary clock
- 4. 6 Button clock
- 5. Cooking tips
- 6. Cooking Table
- 7. Cleaning Your Cooker
- 8. Troubleshooting
- 9. Installation
- Dear Installer
- Safety Requirements and Regulations
- Provision of Ventilation
- Location of Cooker
- Conversion
- Positioning the Cooker
- Moving the Cooker
- Lowering the Two Rear Rollers
- Completing the Move
- Fitting the Stability Bracket or Chain
- Repositioning the Cooker Following Connection
- Conversion to Another Gas
- Levelling
- Gas Connection
- Pressure Testing
- Electrical Connection
- Final Checks
- Final Fitting
- Customer Care
- 10. Conversion to LP Gas
- 11. Circuit Diagram
- 12. Technical Data
- BACK_RM 2018

29
INSTALLATION
Check the appliance is electrically safe and gas sound when you have nished.
Conversion to Another Gas
If the appliance is to be converted to another gas do the
conversion at this point. See the conversion section of these
instructions.
Levelling
You are recommended to use a spirit level on a shelf in one of
the ovens to check for level.
Place the cooker in its intended position taking care not to
twist it within the gap between the kitchen units as damage
may occur to the cooker or the units.
The front feet and rear rollers can be adjusted to level the
cooker.
To adjust the height of the rear of the cooker, use a 13 mm
spanner or socket wrench to turn the adjusting nuts at the
front bottom corners of the cooker.
To set the front turn the feet bases to raise or lower.