Specifications

Sink top
with a hammer. The upper section of the tap hole should
knock out.
The tap hole will have rough edges. Use a suitable rasp to
smooth the edges of the hole. Always work towards the
sink surface avoiding upward strokes that may chip the sink
surface.
For ttings with a larger shaft diameter than 35 mm, the pre-
drilled holes must be enlarged. Use a fret saw with a metal
cutting saw and enlarge the hole as shown in Fig.6. Then
carefully remove the ‘teeth’ with pliers. Do not use force!
Drilling a Hole for Soap Dispensers or Other
Devices.

Before drilling please read safety instructions
supplied with hole saw.

The front face must be fully supported to prevent
cracking when drilling or cutting.

WARNING!
Any machining operation will produce ne particles
of dust. Drilling or cutting MUST be carried out in a
well-ventilated area.
If a hole is required, but has not been supplied in the sink,
proceed as follows:
1. Decide whether the bowl is to be left or right handed
when the sink is tted. You will require a 35 mm
diamond tipped hole saw (not supplied).
2. Using a 35 mm hole saw, carefully cut out the tap hole
(Fig.7).
Clip Preparation
There are three methods of clip tting covered in this guide.
Only one will be supplied with each sink:
• Screw down fixing (Amethyst 1.5)
• Pin fixing (Amethyst 1.0, Magma 1.0, Magma 1.5)
• Screw down ‘U’ clamps (Paragon)
Screw Down Fixing (Amethyst 1.5)
1.
Locate the clamps then give a gentle tap to secure in
the slot (Fig.8).
2. Hinge the clamps away from the sink edge.
Pin Fixing (Amethyst 1.0, Magma 1.0, Magma 1.5)

Important: The clamps are designed to be tted
once. Ensure that the clamps are facing the correct
way before securing in place. Removal will not be
possible once tted.
1. Position the clamps over the holes in the sink. Push the
clamps down ensuring that the base of the clamps are
at against the sink surface. If a clip is tight then, using a
at screwdriver, tap on the base until it snaps into place.
2. Tap the pins on the clamps until the ends of the pins are
level with the top edge of the clamps (Fig.9).
3. Hinge the clamps away from the sink edge.
Screw Down ‘U’ Clamps (Paragon 1.5)
1.
Drill four 8 mm holes as in Fig.10.
2. Tap in the four metal inserts supplied. Additionally,
Epoxy resin adhesive may be required on particleboard
worktops. Do not t the ‘U’ clamps at this point.
Fig.8
Fig.5
Fig.6
Fig.7
Fig.9
30 mm
8
mm
8
mm
Fig.10