COMPOSITE INSET SINKS WITH FIXED POSITION CLIPS Installation Instructions & Aftercare Information Instructions for Cubix, Cubix Gemini & Lunar
INSTALLATION Installer Fig.1 Please leave this leaflet with the user, as it contains valuable after care advice. Notes During installation, take care to protect the sink nn from scuffs and scratches. Avoid straining and overtightening of all plumbing nn fixtures connected to the sink. Carefully check that the moulding and edges of the nn sink are dead level so that water will flow off the drainer. Fig.
If a taphole is required, but has not been supplied in the sink, proceed as follows: 1. 2. 3. Fig.5 Decide whether the bowl is to be left or right handed when the sink is fitted. You will require a 35 mm hole saw (supplied with selected products). On the reverse side of the sink you will find a location point for tap cut-out (Fig.3). Using the 35 mm hole saw, carefully cut out the tap hole. Fitting the clips There are two methods of fitting the clips: • • Screw down fixing or, Pin fixing Fig.
AFTER CARE Day-to-day care Chemical Resistance Routine cleaning of your composite sink is easy if the following simple procedure is followed: The composite sinks are resistant to just about any chemical found in the home, but be careful, as your waste system may not be resistant. After use wipe the bowl and drainer with a soft damp soapy cloth and rinse with clean water. In hard water areas, an application of proprietary cream cleaner will avoid any buildup of a dull film of waterborne deposits.
