Specifications

B
C
D
A
Fig.4
Fig.3
A – Threaded insert, B – Fixing clamp, C – Bowl, D – Seal
Fitting the Bowl
Position the bowl to the worktop. Using the xing clamps and
screws (Fig.3), secure the bowl to the worktop (Fig.4).

DO NOT tighten fully at rst attempt.

DO NOT overtighten the clamps.
Remove any surplus sealing material or wipe away any excess
sealant.
Note: Some bowls may require additional support (this
should be supplied and tted by your installer).
Fitting the Square Overflow Pipework
(Kube & Quadbowl models)
The overow pipework for the square style underbowls may
require modifying to t.
Fig.5 shows the suggested areas of the overow pipework
that may need to be cut. Measure the pipework, and cut the
areas show as required. Fit together as normal.
To ensure a watertight seal, apply silicon sealant onto the
sink-side face of the rubber seal before tting it to the sink
(Fig.6).
110 mm
27 mm
Rubber seal
Sink-side face
Silicon sealant
Fig.5
Fig.6