User guide
24
The oven light is not working
The bulb has probably blown. You can buy a
replacement bulb (which is not covered under the
guarantee) from most electrical stores. Ask for an Edison
screw tting 15 W 230 V lamp, FOR OVENS (Fig.6-1). It
must be a special bulb, heat resistant to 300 °C.
Before removing the existing bulb, turn o the power
supply and make sure that the oven is cool. Open the
oven door and remove the oven shelves.
Locate the bulb cover and unscrew it by turning it
counter-clockwise – it may be very sti (Fig.6-2).
Taking care to protect your ngers with a glove in case
the bulb should shatter, unscrew the old bulb.
Screw in the new bulb clockwise and then screw the
bulb cover back on. Turn on the electricity supply and
check that the bulb now lights.
The oven door is misaligned
The bottom hinge of the left hand oven door can be
adjusted to alter its angle (Fig.6-3). Loosen the bottom
hinge xing screws and use the notch and a at bladed
screwdriver to move the position of the hinge to set the
hinge position (Fig.6-4).
Retighten the hinge screws.
ArtNo.320-0006 Oven door hinge adjustment 1
Fig. 6-3
Eect of hinge adjustment – exagerrated for clarity
ArtNo.320-0007 Oven door hinge adjustment 2
Fig. 6-4
Centreline of hinge pin
Oven door omitted for clarity