Users Guide & Installation Rangemaster Ceramic Hob Professional Ceramic Hob COD. 01080GB - 30.05.
EASY GUIDE Dear Customer, Thank you for purchasing one of our products. It is easy to use; but please read these instructions in order to obtain the best results. These instructions are only valid for the countries of destination, the identification symbols of which are marked on the appliance. The manufacturer shall not be held responsible for any damages to persons or property caused by incorrect installation or use of the appliance.
EASY GUIDE IMPORTANT: Remember: - Place the pan on the cooking zone before turning the control on. - Use pots and pans with flat, solid bases. - Use pots with the same diameter as the cooking zones or slightly larger. - Dry the bottom of the pot before putting it on the cooking zone. - Do not scrape the pot along the glass. This will damage it. - While you are using the hotplate, please, keep children well away. Make sure that pot handles are in a safe position.
EASY GUIDE Cleaning - If any plastic item, kitchen foil, sugar or food containing sugar is accidentally allowed to melt on the hot surface, remove it immediately with a scraper while the hob is still hot to avoid the risk of damage to the surface. - After some use, metal marks and scratches (fig. 4) due incorrect cleaning and the wrong use of the pots may appear on the hob top. The scratches are difficult to remove, but they do not compromise the good working of the hob.
ISTALLATION TECHNICAL INSTRUCTIONS FOR THE INSTALLER 2) FIXING - Screw the fixing brackets to the hob (fig 7). The installation and service procedures given below may only be carried out by a competent technician. Failure to install the appliance correctly could be dangerous and invalidate any warranty or liability claims. The manufacturer cannot be held responsible for any damage to persons or property caused by incorrect installation or use of the appliance.
ISTALLATION INSTALLATION 3) Electrical Connection Recommended cable type: Rubber H05 RR_F of minimum 2.5 mm2 conductor size for single phase. This appliance must be installed by a qualified electrician to comply with the relevant Institute of Electrical Engineers (I.E.E.) regulations and also the local electricity supply company requirements. WARNING: THIS APPLIANCE MUST BE EARTHED Make sure that the mains characteristics (voltage, nominal, power, etc.
INSTALLATION SERVICING Before doing any servicing, disconnect the appliance from the power supply. 7) Replacing parts To replace internal components it is necessary to remove the appliance from the worktop. Turn the hob over, loosen the screws and remove the base. It is possible to work on the plates, controls, clamps and input cable. When replacing the input cable, keep the “earth” conductor longer than “live” ones. Follow the advice given in “Electrical connection” section.
RANGEmaster Clarence Street, Royal Leamington Spa, Warwickshire, CV31 2AD, England. Tel: +44 (0) 870 789 5107 Fax: +44 (0) 1926 450526 E-mail: consumers@rangemaster.co.uk -VI www.rangemaster.co.
