User guide

INSTALLATION
Check the appliance is electrically safe when you have nished.
21
ArtNo.110-0008 - 110 ceramic door clearances
130 mm min
ArtNo.110-00129 - 110 ceramic - Toledo XT min spacings
75 mm
min
75 mm
min
650 mm
min
905 mm
min
930 mm
max
ArtNo.110-0018 - 110 induction 6BC min positions above cooker
410 mm min
1110 mm min*
**
Fig.7-1
Fig.7-2
Fig.7-3
Fig.7-4
Positioning the Cooker
The diagram shows the minimum recommended distance
from the cooker to nearby surfaces (Fig.7-1).
The cooker should not be placed on a base.
Above hotplate surround should be level with, or above, any
adjacent work surface.
A gap of 75 mm should be left between each side of the
cooker ABOVE the hotplate level and any adjacent vertical
surface.
For non-combustible surfaces (such as unpainted metal or
ceramic tiles), this can be reduced to 25 mm.
A minimum space of 650 mm is required between the top of
the hotplate and a horizontal combustible surface.
Fig.7-2 shows the suggested clearances above the cooker.
*Any cookerhood should be installed in accordance with the
hood manufacturer’s instructions.
**Any splashback must be tted in accordance with the
manufacturers instructions. Allowance should be made for the
ue trim, which is tted to the cooker hob.
Surfaces of furniture and walls at the sides and rear of the
appliance should be heat, splash and steam resistant. Certain
types of vinyl or laminate kitchen furniture are particularly
prone to heat damage and discolouration. We cannot accept
responsibility for damage caused by normal use of the
cooker to any material that de-laminates or discolours at
temperatures less than 65 °C above room temperature.
We recommend a gap of 1110 mm between units to allow
for moving the cooker. Do not box the cooker in – it must
be possible to move the cooker in and out for cleaning and
servicing.
If the cooker is near a corner of the kitchen, a clearance of
130 mm is required to allow the oven doors to open (Fig.7-3).
The actual opening of the doors is slightly less but this allows
for some protection of your hand as you open the door.
Moving the Cooker

On no account try and move the cooker while it is
plugged into the electricity supply.

The cooker is very heavy, so take great care.
We recommend that two people manoeuvre the cooker.
Make sure that the oor covering is rmly xed, or removed,
to prevent it being disturbed when moving the cooker
around.
Remove the polystyrene base pack. From the front, tilt the
cooker forward and remove the front half of the polystyrene
base (Fig.7-4). Repeat from the back and remove the rear half
of the polystyrene base.