Specifications
R
(FM10) SEMCON LAND ROVER OWNER GUIDE VER 2.00 EURO
LANGUAGE: english-en; MARQUE: landrover; MODEL: Range
Rover Evoque
Garage door opener
63
5. Press and hold the programmed garage
door opener button and observe the
indicator lamp.
If the indicator lamp illumination is
continuous, programming is complete
and your device should operate when
the garage door opener button is
pressed and held for approximately 1
to 2 seconds and then released.
If the indicator lamp blinks rapidly for
2 seconds and then illuminates
continuously, proceed with the
following programming instructions
for rolling code device equipment.
TO ERASE ALL PROGRAMMING
For first time programming, make sure the
engine is switched off:
1. Make sure the ignition is on (but with the
engine switched off).
2. Press and hold the 2 outer buttons on the
transceiver in the rear view mirror. Keep
the buttons pressed until the indicator
lamp begins to flash (this will take
approximately 10 seconds), then release
the buttons.
All memories in the garage door opener have
now been cleared.
Note: Do not perform this procedure when
programming the additional garage door
opener buttons.
ROLLING CODE DEVICE EQUIPMENT
PROGRAMMING
Note: The assistance of a second person, may
make the following steps quicker and easier.
Once the button has been pressed there are
only 30 seconds in which to complete Step 3.
1. At the garage door opener receiver (motor
head unit) in the garage, locate the learn or
smart button/switch.
The name of the button or switch may
vary between manufacturers.
2. Press and release the learn or smart
button.
3. Return to the vehicle and firmly press and
hold the programmed garage door opener
button for 2 seconds and release.
4. Repeat the press, hold, release sequence 3
times to complete the programming
process.
The garage door opener in the rear view mirror
should now activate the rolling code device.
REPROGRAMMING A SINGLE
GARAGE DOOR OPENER BUTTON
To programme a device to a previously
programmed button:
1. Press and hold the desired
pre-programmed garage door opener
button for at least 20 seconds, but no
longer than 30 seconds, until the indicator
lamp begins to flash.
2. Without releasing the rear-view mirror
button, position the hand-held transmitter
approximately 50 to 150 mm (2 to 6
inches) away from the transceiver in the
rear-view mirror, keeping the indicator
lamp in view.
3. Carry out Step 3 of Programming.