Specifications

R
(FM10) SEMCON LAND ROVER OWNER GUIDE VER 2.00 EURO
LANGUAGE: english-en; MARQUE: landrover; MODEL: Range
Rover Evoque
Exterior lights
49
With the lighting control in the OFF position or
in the AUTO position, while the lighting
conditions do not require the headlamps to be
on, then the Daytime running lamps will switch
on automatically under the following
conditions:
 The engine is running.
 The gear selector is out of Park (automatic
transmission).
 The parking brake is not applied - market
dependent.
HEADLAMP COURTESY DELAY
This feature operates whenever the lamps
master switch is in the AUTO (5) position and
the ignition is turned off. The headlamps will
remain illuminated for up to 240 seconds.
Note: The time delay may be changed via the
Vehicle Set-up menu. See 40, INSTRUMENT
PANEL MENU.
The Courtesy delay can be switched off at any
time by pressing the headlamp button on the
Smart key.
HIGH BEAM ASSIST
This feature of the Xenon lighting automatically
selects and deselects the high beam, under
specific conditions of road lighting and in the
absence of other vehicle’s lights. The system is
only active when the ambient light drops below
a predetermined level.
Note: It is not recommended that High beam
assist is used while driving off road.
For High beam assist to become operational,
the main lighting switch must be in the AUTO
position (5), with dipped beam headlamps
selected.
The Instrument panel warning lamp illuminates
when High beam assist is selected. See 47,
HIGH BEAM ASSIST (GREEN).
High beam assist will activate only when the
vehicle's speed exceeds 40 km/h (25 mph).
The system will deactivate when the vehicle's
speed drops below 24 km/h (15 mph).
To manually select high beam, move the stalk
to the high beam position as normal. To return
to High beam assist, move the stalk back to the
central position.
To manually override to dipped beam from
high beam, pull the stalk to the flash position
(2) and High beam assist will be cancelled. To
return to High beam assist, push the stalk to
the high beam position (1) and then return it to
the central position.
To turn off High beam assist, turn the main
lighting control from Auto to headlamps.
This feature can be disabled/enabled via the
Vehicle Set-up menu. See 40, INSTRUMENT
PANEL MENU.
The following may affect the operation of High
beam assist:
 Highly reflective road signs.
 Dimly lit road users, for example cyclists or
pedestrians.
 Adverse weather conditions, for example
rain or fog.
 Dirty or obscured sensor.
 Dirty, damaged, or misted windscreen.
 Oncoming vehicles partially obscured by a
central highway barrier.
Unless required or prohibited by
law, the Daytime running lamps
feature can be disabled or enabled
by a Dealer/Authorised Repairer.