Specifications

R
(FM10) SEMCON LAND ROVER OWNER GUIDE VER 2.00 EURO
LANGUAGE: english-en; MARQUE: landrover; MODEL: Range
Rover Evoque
Airbags
39
Airbags inflate at high speed and can
cause injuries. To minimise the risk of
injury, make sure all occupants wear
correctly positioned seat belts, sit
correctly in the seats and position the
seats as far back as is practicable.
Airbag deployment is accompanied by
a very loud noise which may cause
discomfort and temporary loss of
hearing.
After inflation, some airbag
components will be very hot. Do not
touch the airbag components until
they have cooled sufficiently.
AIRBAG WARNING LAMP
The airbag warning lamp is displayed in the
Instrument panel and will illuminate as a bulb
check when the ignition is turned on. See 45,
AIRBAG (AMBER).
If the warning lamp indicates that a
fault is present in the system, do not
use a child restraint on the front
passenger seat.
If any of the following warning lamp conditions
occur, the vehicle should be checked by your
Dealer/Authorised Repairer immediately.
 The warning lamp fails to illuminate when
the ignition is turned on.
 The warning lamp fails to extinguish within
8 seconds of the ignition being turned on.
 The warning lamp illuminates at any time
other than the bulb check, when the
ignition is on.
When the ignition is switched on, a diagnostic
control unit monitors the readiness of the
system’s electrical circuits. The elements of the
Supplementary Restraint System (SRS) being
monitored include:
 SRS warning indicator.
 Rotary coupler.
 Airbag modules.
 Front seat belt pre-tensioners.
 Front seat belt buckle switches.
 Front seat track position sensor.
 Airbag diagnostic control unit.
 Crash and rollover sensors.
 Airbag wiring harness.
AIRBAG SERVICE INFORMATION
Do not attempt to service, repair,
renew, modify, or tamper with, any
part of the SRS. This includes wiring
or components in the vicinity of SRS
components. Doing so may cause the
system to trigger, or render the
system inoperative.
Do not use any electrical test
equipment or devices in the vicinity of
SRS components or wiring. Doing so
may cause the system to trigger, or
render the system inoperative.
All of the following operations should be
carried out only by a Dealer/Authorised
Repairer, or suitably qualified person:
 Removal or repair of any wiring or
component in the vicinity of any SRS
components.
 Fitment of electrical, or electronic,
equipment and accessories.
 Modification to the front or sides of the
vehicle exterior.
 Attachment of accessories to the front or
sides of the vehicle.
DISABILITY MODIFICATIONS
Occupants with disabilities which may require
modification of the vehicle, must contact a
Dealer/Authorised Repairer before any
modifications are made.