Specifications

L
(FM10) SEMCON LAND ROVER OWNER GUIDE VER 2.00 EURO
LANGUAGE: english-en; MARQUE: landrover; MODEL: Range
Rover Evoque
Wheel changing
246
1. Locate the jack under the relevant jacking
point.
Note: Do not allow the jack to contact the
sill at any other point as damage may
result.
Note: The Sports pack sills include arrows
to identify jacking points.
2. Unfold the cranking handle from its stowed
position on the jack. Fit the wheel nut brace
to the end of the cranking lever.
3. Rotate the handle clockwise to raise until
the jack pin locates into the jacking point.
4. Continue raising the vehicle until the wheel
is clear of the ground.
5. Remove the wheel nuts and place them
together where they cannot roll away.
6. Remove the wheel and place to one side.
Do not lay the wheel on its face, as this may
damage the finish.
7. Fit the temporary spare wheel to the hub.
8. Re-fit the wheel nuts and lightly tighten
them. Make sure the wheel is making
contact with the hub evenly.
9. Make sure the space under the vehicle is
clear of obstructions and lower the vehicle
slowly and smoothly.
10. With all wheels on the ground and the jack
removed, fully tighten the wheel nuts. The
wheel nuts must be tightened in sequence
(see the illustration below) to the correct
torque of 133 Nm (98 lb.ft).
Note: If it is not possible to torque the wheel
nuts when a wheel is renewed, they should be
set to the correct torque as soon as possible.
Check and adjust the tyre pressure as soon as
possible.