Specifications

R
(FM10) SEMCON LAND ROVER OWNER GUIDE VER 2.00 EURO
LANGUAGE: english-en; MARQUE: landrover; MODEL: Range
Rover Evoque
Wheel changing
245
Note: A code number is stamped onto the
underside of the adaptor. If a replacement
adaptor is required, you will be asked to quote
this number. Make sure the number is
recorded and kept safe, but should not be kept
with the vehicle.
1. Insert the wheel nut adaptor into the
locking wheel nut, making sure it is fully
engaged.
2. Locate the wheel brace over the adaptor
and unscrew the wheel nut half a turn
counter-clockwise.
3. After raising the vehicle on the jack,
remove the locking wheel nut.
Note: After use store the wheel nut adaptor
correctly in the tool kit.
WHEEL CHANGING
Before raising the vehicle or changing a wheel,
make sure you read and comply with the
following warnings:
Make sure the jack is on firm level
ground.
Never place anything between the jack
and the ground, or the jack and the
vehicle.
Position the jack from the side of the
vehicle, in-line with the appropriate
jacking point.
Do not attempt to raise the vehicle
unless the jack head is fully engaged
in the jacking point. Only jack the
vehicle using the approved jacking
points.
WARNING - THAT NO PERSON
SHOULD PLACE ANY PORTION OF
THEIR BODY UNDER A VEHICLE THAT
IS SUPPORTED BY A JACK.
Take care when loosening the wheel
nuts. The wheel brace may slip off if
not properly attached and the wheel
nuts may give way suddenly. Either
unexpected movement, may cause an
injury.
Take care when lifting the spare wheel
and removing the punctured wheel.
The wheels are heavy and can cause
injuries if not handled correctly.
Do not start or run the engine while the
vehicle is supported only by a jack.
Jack up the vehicle using only the
jacking points described, or damage to
the vehicle could occur.
Note: Your vehicle may be fitted with a tilt
sensor which activates the alarm if the vehicle
is tilted in any direction after it has been locked.
To lock the doors while changing the wheel,
and avoid the alarm activating, the tilt sensor
can be temporarily disabled. See 16, TILT
SENSOR.
Before rasing the vehicle, use the wheel nut
brace to slacken the wheel nuts half a turn
counter-clockwise.