Specifications

R
(FM10) SEMCON LAND ROVER OWNER GUIDE VER 2.00 EURO
LANGUAGE: english-en; MARQUE: landrover; MODEL: Range
Rover Evoque
Tyre repair kit
241
9. Inflate the tyre to a minimum of 1.8 bar (26
psi, 180 kPa) and a maximum of 3.5 bar
(51 psi, 350 kPa).
Note: When pumping the sealant through
the tyre valve, the pressure may rise up to
6 bar (87 psi, 600 kPa). The pressure will
drop again after approximately 30
seconds.
10. During the inflation, switch the
compressor off briefly, to check the tyre
pressure using the gauge mounted on the
compressor.
Note: It should not take longer than 10
minutes to inflate the tyre. If, after a
maximum of 10 minutes, the tyre has not
yet reached minimum pressure, the tyre
should not be used.
11. Once the tyre has been inflated to the
required pressure, switch off the
compressor. If desired, the ignition may be
turned off after the compressor has been
turned off.
12. Remove the power connector from the
auxiliary power socket.
13. Remove the inflation hose from the tyre
valve, by unscrewing it as quickly as
possible in an counter clockwise direction.
14. Replace the inflation hose protective cap
and the tyre valve cap.
15. Make sure the tyre repair kit (including the
bottle and receiver caps) is placed securely
in the vehicle. You will need to use the kit
to check the tyre pressure after a maximum
of 10 km (6 miles), so make sure it is easily
accessible.
16. Immediately drive the vehicle for a
maximum of 10 km (6 miles). This will
allow the sealant to coat the inner surface
of the tyre and form a seal at the puncture.
CHECKING THE TYRE PRESSURE
AFTER A REPAIR
When driving the vehicle, if you
experience vibrations, abnormal
steering, or noises, reduce speed
immediately. Drive with extreme
caution and reduced speed, to the first
safe place to stop the vehicle. Visually
examine the tyre and check its
pressure. If there are any signs of
damage or deformity to the tyre, or the
tyre pressure is below 1.3 bar (19 psi,
130 kPa), do not continue driving.
Consult a tyre repair centre or your
Dealer/Authorised Repairer, for
advice concerning the renewal of a
tyre after using a tyre repair kit.
1. Drive the vehicle for a maximum of 10 km
(6 miles) then stop in a safe place. Carry
out a visual examination of the tyre’s
condition.
2. Remove the repair kit from the vehicle.
3. Screw the inflation hose connector firmly
onto the tyre valve.
4. Read the tyre pressure from the gauge.
5. If the pressure of the sealant filled tyre is
above 1.3 bar (19 psi, 130 kPa) adjust the
pressure to the correct value.
6. Make sure that the compressor switch is in
the off (O) position and insert the power
cable connector into the auxiliary power
socket.
Switch on the ignition. Alternatively, if the
vehicle is not in a confined space the
engine can be started.
7. Switch the compressor to on (l) and inflate
the tyre to the correct pressure. See 257,
WHEEL AND TYRE SIZES.