Specifications

R
(FM10) SEMCON LAND ROVER OWNER GUIDE VER 2.00 EURO
LANGUAGE: english-en; MARQUE: landrover; MODEL: Range
Rover Evoque
Maintenance
203
If the vehicle has been driven
recently, do not touch exhaust system
components until they have cooled.
Access to a rear fog lamp housing is from
beneath and behind the rear bumper. The bulb
holder is a black plastic unit that incorporates
the bulb. No tools are required but a torch may
be of use.
1. To remove the bulb holder, press in the
outer wings on the black plastic unit and
pull the holder free of the housing.
2. To separate the bulb holder from the
electrical connector, first push up the
connector lock.
3. Push in the release mechanism while
pulling the connector and bulb holder
apart.
Note: Inside the bulb holder are 3 locating
lugs. When fitting the new bulb unit, the lugs
must mate up to the connector correctly.
Refitting is a reverse of the removal process.
Make sure the connector lock is pressed down
and that the bulb unit locates securely into the
fog lamp housing.
WIPERS SERVICE POSITION
Before changing a front wiper blade, the wiper
arms must be set in the 'service' position as
follows:
Note: The Smart key must remain in the vehicle
while the wiper blades are being renewed.
1. Make sure the ignition is turned off.
2. Turn the ignition on and then off again.
3. Immediately push the wiper control down
to start the single wipe operation and turn
the ignition on again.
The wipers will move to their service
position.