Specifications
R
(FM10) SEMCON LAND ROVER OWNER GUIDE VER 2.00 EURO
LANGUAGE: english-en; MARQUE: landrover; MODEL: Range
Rover Evoque
Standard audio system
179
3. Select a clock function.
4. Once the change has been entered, press
OK.
LANGUAGE SELECTION
To select a display language:
1. Press the MENU (2) button.
2. Select Language.
3. Once the change has been entered, press
OK.
DIGITAL (DAB) RADIO
If your vehicle is equipped for digital radio,
press the RADIO (7) button to select either of 2
groups DAB1 or DAB2. These 2 groups permit
the storing of a total of 20 preset stations or
'services' (10 in each group) using the buttons
0-9 on the keypad (5).
DAB radio can significantly increase the
number of radio stations available. The DAB
signals are transmitted to most major cities,
towns and motorway networks.
Unlike AM/FM radio, digital transmits several
services on a single frequency. This group of
services is known as an ensemble. There may
be a number of ensembles receivable in some
areas, each typically carrying between 6 and 12
services.
Digital radio is transmitted from regional and
local transmitters. Some services are national
or regional and are replicated on multiple
transmitters throughout the region or country.
Other services are local and only available
within a limited range of one transmitter.
FINDING DIGITAL SERVICES
Press the seek buttons (8 or 9) to search the
waveband to find the local active ensembles. Or
alternatively the steering wheel seek buttons
can perform the same function.
The national channels use the same ensembles
throughout a country and so there is usually no
need to search for these. If you have stored
your favourite national channels already then
they will usually be found immediately on the
same pre-set buttons.
If reception is lost when the vehicle is in
motion, the vehicle may be moving out of
range of the ensemble. Use the seek buttons (8
or 9) to search for services which are stronger
in that area.
Note: If any auxiliary electrical equipment is
connected to the vehicle, DAB radio reception
capability may be reduced.
SELECTING AND STORING DIGITAL
SERVICES
Select DAB1 or DAB2. In each band the active
station will be the last one used. To select
another station, press the appropriate preset
button (0 to 9).
Any preset can be used to store any Digital
Radio service, from any ensemble. If you
switch between presets which are on different
ensembles, the tuning time can take a few
seconds (the word 'Searching....' briefly
appears on the screen). Switching between
services within the same ensemble is virtually
immediate.
If there is no service stored on a preset, or if the
service is not receivable at the current location,
the message 'No Reception' will be displayed.
If the service you want is not already stored in
a preset button or cannot be received, then you
can step through the other services in the
current ensemble by repeated short presses on
the Seek-up or Seek-down buttons. At the end
of the ensemble, a further press will show
'Searching....' for a few seconds and then the
next ensemble will be shown. You can then
step through each service in this new ensemble
by repeated short presses as above.