Owner's Manual
Features
Front Panel
1 . Microphone Input: Connect a
condenser or dynamic microphone
(such as the included gooseneck
microphone)
to
this
XLR
input. Zone
Pager is set
to
Dynamic mode by
default. The mode can be changed
to
Condenser from the Zonetech front
panel
or
in
the Halogen software.
2. Zone
1-6
Buttons: Press and release
these buttons
to
select a zone
for
paging from
the
XLR mic input. These
buttons may also be used
for
programming Groups. For multi-zone
programming and audio routing
possibilities the Zonetech processor
or Halogen software can be used.
D
D@ ~g
:---===:
~-r-tt-t-ta.a"W
0
11.-~ll--'-;;
o'
0
•
3. Zone
1-6
LEDs: These LEDs will illuminate when a zone is selected for paging.
4. Group
1-2
Buttons: Press and release a Group button
to
select a Group. Groups contain
multiple assigned zones which are used
to
page specific areas (for example, "Outdoor
Dining Areas"
or
"Indoor Dining Areas").
To assign a zone
to
a Group:
• Select
the
zones you want
to
be included
in
a Group.
• Press and hold the group button until it flashes.
5. Group
1-2
LEDs: The
LED
will illuminate
to
indicate that a Group is selected for paging.
6.
Page All Button: Press and release this button
to
select all zones for paging.
7.
All
LED: This LED will illuminate yellow
to
indicate that all zones are selected for paging.
8. Ready LED: This
LED
will illuminate green
to
indicate that the paging station may be
used for an announcement.
9.
Busy LED: When used with Terminal 1010x, this
LED
will illuminate red
to
indicate that a
higher priority page is in operation.
10. Chime LED: This LED will illuminate yellow during the chime. Once finished, talk into the
microphone
to
page.
11
. Page Button: Use this button
to
make an announcement with the microphone. The Page
button can be set
to
either Toggle
or
Momentary mode using Zonetech's web controls
or
in the Halogen software. When set
to
Toggle, press and release the Page button
to
page;
press and release the Page button again when paging is finished. When set
to
Momentary, press and continue
to
hold the Page button while paging; release the Page
button once paging is finished.
5