Owner's Manual
14. Water and Moisture (if applicable): This
product
should
be
kept away from direct
contact
with liquids. The apparatus shall
not
be
exposed
to
dripping
or
splashing and that
no
objects filled with liquids, such as vases, shall
be
placed
on
the
apparatus.
15. Caution (if applicable): Danger
of
explosion
if
battery is incorrectly replaced. Replace only with the same
or
equivalent type.
Batteries (a battery
pack
or
an installed battery) shall
not
be
exposes
to
excessive heat such as sunshine, fire, etc.
16. (If applicable) Where
the
mains plug
or
an appliance coupler is used
as
the disconnect device, the disconnect device shall remain
readily operable.
17. Protective earthing terminal (if applicable): The apparatus should be connected
to
a mains
socket
outlet with a protective @
earthing connection.
..L.
• Denmark
(Oanmarl<,:
Apparatets stikprop skal tilsluttes
en
stikkontakt med jord, som giver forbindelse til stikproppens jord. -
• Finland (Suom,): Laite
on
liitettiivii suojakoskettimilla varustettuun pistorasiaan.
• Norway (Norge): Apparatet
ma
tilkoples jordet stikkontakt.
• Sweden (Sverige): Apparaten skall anslutas till jordat uttag. [g]
18. For Class II
ap
paratus onl
y:
This symbol means
the
equipment is a Class
II
or
double-insulated electrical appliance. It D
has been designed in
such
a
way
that
it
does
not
require a safety connection
to
electrical earth.
19
. Class II Wiring (if applicable):
To
reduce the risk
of
electric shock,
the
external wiring connected
to
the
terminals with "Class
II
Wiring" requires Class
II
wiring installed
by
an instructed person
or
the
use
of
ready-made leads
or
cords.
20. Warning (if applicable): Provide an earthing connection before
the
mains plug is connected
to
the
mains. When disconnecting
the
earthing connection, be sure
to
disconnect
it
after pulling
the
mains plug
out
from the mains.
21. This apparatus is
for
professional use only. Intended operational climate: moderate.
22. (If applicable) When moving
or
not
using the appliance, secure the
power
cord
(e.g.,
wrap
it
with a cable tie). Be careful
not
to
damage
the
power
cord. Before using it again, make sure
the
power
cord
has
not
been damaged.
If
the
power
cord
has been
damaged
at
all, bring the unit
and
cord
to
a qualified service technician
for
repair
or
replacement
as
specified
by
the
manufacturer.
23. Warning (if
app
licable):
To
prevent possible hearing damage,
do
not
listen at high volume levels
for
long
periods.
~
24. Warning (if applicable): Please refer
to
any important information (e.g., electrical, safety, etc.) printed on
the
exterior
~
bottom enclosure
or
rear panel before installing
or
operating the product. 4
25. Warning (if applicable): Terminals marked with
the
lightning
bolt
symbol
may
be
of
sufficient magnitude
to
constitute a risk
of
electric shock.
Service Instructions
• Disconnect
power
cord
before servicing.
• Replace critical components &.
only
with factory parts
or
recommended equivalents.
• For AC line powered units: Before returning repaired unit
to
user, use an ohmmeter
to
measure from both
AC
plug blades
to
all
exposed metal parts. The resistance should
be
more
than
2,000,000 ohms.
Safety Notices
NO
USER- SERVICEABLE PARTS INSIDE.
REFER
SERVICING TO QUALIFIED SERVICE I Risk of electric shock. Z
CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT REMOVE ANY COVER. ~ · • £
PERSONNEL ONLY. •
__
o_o_no_t_o_
pe
_n_. _
_.
7
DANGEROUS VOLTAGE: The lightning flash with arrowhead symbol within
the
equilateral triangle is intended
to
alert
the
~
user
to
the
presence
of
un-insulated "dangerous voltage" within the
product's
enclosure
that
may
be
of
sufficient magnitude
~
to
constitute a risk
of
electric shock. SA 1965
INSTRUCTIONS: The exclamation
point
within
the
equilateral triangle
is
intended
to
alert
the
user
to
the presence
of
"'•
important operating and maintenance (servicing) instructions
in
the
literature accompanying
this
appliance.
~
SA 1966
WARNING: To reduce
the
risk
of
fire
or
electrical shock,
do
not
expose this appliance
to
rain
or
moisture. Electrical
equipment
should
NEVER
be
kept
or
stored in
damp
environments.
CAUTION
(f
or U.
SA
& CANADIAN models on
ly):
TO
PREVENT
ELECTRIC
SHOCK DO NOT
USE
THIS
(POLARIZED)
PLUG
WITH
AN
EXTENS
ION CORD, RECEPTACLE OR OTHER OUTLET UNLESS THE BLADES CAN BE FULLY
INSERTED
TO
PREVENT
BLADE
EXPOSURE.
NOTICE CONCERNING LASER PRODUCTS: DANGER: INVISIBLE LASER RADIATION WHEN OPEN
AND
INTERLOCK FAILED OR
DEFEATED. AVOID DIRECT EXPOSURE TO BEAM. USE OF CONTROLS OR ADJUSTMENTS OTHER THAN THOSE SPECIFIED
HEREIN
MAY
RESULT IN HAZARDOUS RADIATION EXPOSURE.
NOTICE CONCERNING F
CC
REGULATIONS: You are cautioned
that
changes
or
modifications
not
expressly approved
by
the
part
responsible
for
compliance
could
void
the
user's authority
to
operate the equipment. This equipment has been
tested
and found
to
comply with
the
limits
for
a Class B digital device, pursuant
to
Part
15
of
the
FCC rules. These limits are designed
to
provide
reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio
frequency energy and,
if
not
installed and used
in
accordance with
the
instructions,
may
cause harmful interference
to
radio
communications. However, there is
no
guarantee
that
interference will
not
occur
in a particular installation. If this
equipment
does
cause harmful interference
to
radio
or
television reception, which
can
be
determined
by
turning the equipment
off
and
on,
the
user is
encouraged
to
try
to
correct
the
interference
by
one
or
more
of
the following measures:
(a)
reorient
or
relocate the receiving antenna;
(b) move this unit; (c) increase
the
separation between
the
equipment
and
receiver;
(d)
connect
the
equipment into
an
outlet
on
a
circuit different
from
that
to
which
the
receiver
is
connected;
(e)
be sure that all cables are properly shielded, using a choke
or
ferrite
where appropriate;
or
(f)
consult
the
dealer
or
an experienced radio/television technician
for
help.
This device complies with Part
15
of
the
FCC rules. Operation is subject
to
the
following
two
conditions: (1) this device may
not
cause
harmful interference, and (2)
this
device
must
accept
any interference received, including interference that
may
cause undesired
operation.
6