User guide

Manual-3

REAR PANEL DESCRIPTION

1 POWER input connector: is is not a telephone jack! Connect an 18 volt AC center-tapped transformer only. Use only a Rane

model RS 1, shipped with the unit, or other compatible power supply approved by Rane.

2 Chassis ground point: is screw is provided for connection to chassis ground if required. See Chassis Grounding below.

3 HOUSE OUTPUT: e front panel HOUSE LEVEL control aﬀects the volume at this Output. ese balanced ¼" TRS (tip-

ring-sleeve) Outputs connect to a balanced equalizer or ampliﬁer. ough not recommended, unbalanced ¼" TS (tip-sleeve)

cables may be used for short runs (under 3 meters [10 feet]) to an ampliﬁer with unbalanced inputs. See the RaneNote “Sound

System Interconnection” for wiring recommendations.

4 AUX OUTPUT: is delivers the same signal as the HOUSE OUTPUT, but has its own LEVEL control on the rear panel. is

Output is not aﬀected by the front panel HOUSE LEVEL control. ese balanced ¼" TRS (tip-ring-sleeve) Outputs connect to a

balanced equalizer or ampliﬁer (for a possible second listening zone) and follow the same interconnection rules as above.

5 TAPE OUT: ese line level RCA Outputs are intended for use with a tape recorder, but not necessarily restricted to that pur-

pose. You may be creative. ese Outputs are not aﬀected by the HOUSE LEVEL or AUX LEVEL controls.

6 MIC to TAPE OUT switch: In the YES position the Mic signal along with the Program Inputs are routed to the TAPE OUT. In

the NO position only the Program Inputs appear at the TAPE OUTPUT.

7 LINE 1 & 2 INPUTS: connect to stereo sources such as CD players or any line-level device. L1 and L2 may be assigned to Pro-

gram A or Program B via the front panel INPUT switches.

8 PHONO/LINE 1 & 2 INPUTS: ese stereo Inputs are switchable from a PHONO (RIAA) stage for magnetic cartridges

(PHONO switch in) to a LINE level Input suitable for any line level device such as a CD player (PHONO switch out). e

Phono Ground screw connects those extra wires coming out of the turntables.

9 MIC Input: Accepts a ¼" balanced (TRS) or unbalanced (TS) microphone cable, controlled by the MIC LEVEL control on the

front panel.

CLASS 2 EQUIPMENT

MADE IN U.S.A.

RANE CORP.

RIGHT LEFT RIGHT LEFT

LEVEL

YES

PHONO

LINE

PHONO GROUND

600mA

POWER

MP 2

HOUSE AUX

TAPE OUTPUT L2 P2 L1 P1

MIC TO TAPE

MIC

ACN 001 345 482

BALANCED OUTPUTS: TIP = (+), RING = (–), SLEEVE = SIGNAL GROUND

BALANCED MIC INPUT

PHONO

LINE

1 9 5 8

2 3 4 6 7