Operator`s manual

6 800-621-8560
SPECIFICATION & PRODUCT DESIGN
Due to continued product improvement, specification and product design may
change without notice. Such revisions do not entitle the buyer to additions.
Changes or replacements for previously purchased equipment.
SANITATION REQUIREMENTS
Certain areas require specific annotation requirements other than N.S.F. &
U.L. standards. Randell must be advised of these specifications before
fabrication of equipment. In these special circumstances, a revised quotation
may be required to cover additional costs. Failure to notify Randell before
fabrication holds the dealer accountable for all additional charges.
SHIPPING & DELIVERY
Unified Brands will attempt to comply with any shipping, routing or carrier
request designated by dealer, but reserves the right to ship merchandise via
any responsible carrier at the time equipment is ready for shipment. Unified
Brands will not be held responsible for any carrier rate differences; rate
differences are entirely between the carrier and purchaser. Point of shipping
shall be determined by Unified Brands (Weidman, MI/Jackson, MS). At
dealer’s request, Unified Brands will endeavor whenever practical to meet
dealer’s request. Freight charges to be collect unless otherwise noted.
DAMAGES
All crating conforms to general motor carrier specifications. To avoid
concealed damage, we recommend inspection of every carton upon receipt.
In the event the item shows rough handling or visible damage to minimize
liability, a full inspection is necessary upon arrival. Appearance of damage will
require removing the crate in the presence of the driver. A notation must be
placed on the freight bill and signed for by the truck driver at the time of
delivery. Any and all freight damage that occurs to a Randell piece of
equipment as a result of carrier handling is not considered under warranty, and
is not covered under warranty guidelines. Any freight damage incurred during
shipping needs to have a freight claim filed by the receiver with the shipping
carrier. Consignee is responsible for filing of freight claims when a clear
delivery receipt is signed. Claims for damages must be filed immediately
(within 10 days) by the consignee with the freight carrier and all cartons and
merchandise must be retained for inspection.
RETURNED GOODS
Authorization for return must first be obtained from Unified Brands before
returning any merchandise. Any returned goods shipment lacking the return
authorization number will be refused, all additional freight costs to be borne by
the returning party. Returned equipment must be shipped in original carton,
freight prepaid and received in good conditions. Any returned merchandise is
subject to a minimum handling charge (consult factory for rate).
INSTALLATION
Equipment installation is the responsibility of the dealer and/or their customer.
Unified Brands requires all equipment to be professionally installed to ensure
adequate voltage and amperage requirements are met.
It is imperative that the equipment is placed on a level surface that us rated
handle the capacities of the unit and the contents.