Specifications

E. Installation Checklist

After the final location of the unit has been determined refer to the following

checklist prior to start up:

1. Check all exposed refrigeration lines to ensure that they are not kinked, dented or

rubbing together.

2. Check that condenser and evaporator fans rotate freely without striking any

stationary members.

3. Unit must be properly leveled.

4. Plug in unit and turn on main on/off switch.

5. Turn on cold control located inside the base.

6. Refer to the front of this manual for serial number location. Please record this

information in your manual on page 3 now. It will be necessary when ordering

replacement parts or requesting warranty service.

7. Confirm that unit is holding temperature. Set controls to desired temperature for

your particular ambient and altitude (See figure A.).

8. Allow your unit to operate for approximately 2 hours before putting in food this

allows interior to cool down to storage temperature.

Note: All motors are oiled and sealed.

Note: All self-contained models are shipped from the factory with the service valves

open ready for operation.