Quick Start Guide

8
9
Once a device is paired, the LED stays solid blue. ClearDryve
™
will reconnect automatically when Bluetooth
®
is enabled and the device is within range.
To pair ClearDryve
™
with a BT device:
1. Power on ClearDryve
™
.
2. Enable Bluetooth
®
on your device.
3. ClearDryve
™
will display on your device as ClearDryve
™
50. Select it.
4. The LED will change to solid blue.
You can pair ClearDryve
™
to a new device at any time by entering pairing mode again.
To enter pairing mode again:
1. If the headphones is on, turn it off by pressing and holding the MFB.
2. Press and hold the MFB.
2. The LED indicator blinks blue and red, and you will hear “Pairing.”
As soon as it is paired with a device, ClearDryve
™
is ready to make calls or stream music.
Note: When ClearDryve
™
is turned on and not in pairing mode, it will automatically connect with the most recently paired device when it is on.
Call Mode
In Call Mode, you can answer incoming calls, and use your smartphone’s voice assistant to make
hands-free calls.
Quick Access
Answer a call Press the MFB.
End a call Press the MFB.
Ignore a call Press and hold the MFB.
Note: Holding down the MFB for too long (i.e., over 5 seconds) will cause
ClearDryve
™
to power down.
Redial Double-press the MFB
Mute/Unmute Rotate the mic arm up (to mute) or down (to unmute)
Adjust volume Press Vol + or Vol -