Product Overview

The EasyProg has three ways to load or unload the parameters:
- Serial RS-485: Connects to the controller via RS-485 network. EasyProg must be connected to
only one controller in the RS-485 network. In this case, an external power supply through the mini USB
port is required. It is connected to the terminals A, B and Ground of the controller through a three-way
cable.
- Serial TTL: The controller can be connected directly to the EasyProg by Serial TTL through a five-
way cable. Thus, EasyProg can be powered by the controller, or vice versa.
USB Power
EasyProg
RS-485
A - Orange
B - Red
- Brown
A
B
ENVIRONMENTAL INFORMATION
Package:
The packages material are 100% recyclable. Just dispose it through specialized
recyclers.
Products:
The electro components of Full Gauge controllers can be recycled or reused if it is
disassembled for specialized companies.
Disposal:
Do not burn or throw in domestic garbage the controllers which have reached the end-of-
life. Observe the respectively law in your region concerning the environmental
responsible manner of dispose its devices. In case of any doubts, contact Full Gauge
controls for assistance.
NOTE: SHOULD CONSULT THE MANUAL CONTROLLER
TO VERIFY THAT IS COMPATIBLE WITH Easyprog ver. 2
or higher, BEFORE MAKING A CONNECTION AMONG THEM.
!
- USB: Can be connected to the computer via USB port, no Windows driver installation is required since
EasyProg uses HID (Human Interface Device) communication. The parameters can be copied,
edited, and saved using Sitrad's Preset Editor. The USB port can also function to supply electric power
to EasyProg and the Controller (when not used along with USB and Serial TTL).
Note: Always use shielded USB cables with a maximum length of 6 ft (1.8 m).
Note: Whenever the parameters from a controller model are uploaded to EasyProg, the information
must be downloaded to controllers with the same model.
6. FORMS OF CONNECTION AND CONNECTION DIAGRAMS
Copyright 2017
SET
---
NOTE 2: CONNECTING TO EASYPROG ver. 4 or higher ON THE COMPUTER, THE INDICATOR FLASHES TWO
SOMETIMES, FIRST INFORMING THE FIRMWARE VERSION AND ITS RELEASE AND THEN IT SHUTDOWNS. AFTER,
REMAINS ONLY THE LEDS AND ACCESSORIES ON THE MAGENTA COLOR.
!