User Guide

PAGE 1
Form Na. 1528023000 CONTROL APPLICATIONS Room Air Units, Packaged Terminal Air Conditioners, Through-the-Wall Units. DESCRIPTION The C17 is used on air conditioning equipment and provides either Manual or Automatic Heat Cool change-over. The C17-100 has two separate switches for heating and coaling. po" p— ~ IMPORTANT Ci-100 CONTROL 1. The schematic drawings and other information included in these The control has two SPIT switches.
PAGE 2
Below are the factory settings with the dial knob on *Cold" and *Warm" cam positions, Cold Cam Cut-Out Cutout On Cooling 71°F. On Heating B4F, Warm Cam On Cooling 101°F, On Heating SWITCH TERMINAL WIRING Cy i CLOSE ON TEMPERATURE RISE SWITCH 8 Rainstorms 4.546 ENLISTMENT SCREW, DO Fat NOT ADJUST INSTALLATION-MOUNT CONTROL 1. Disconnect electrical power from unit. 2. Remove knob and save. 3. Remove unit panels to access the Thermostat area. 4. Label and identify wiring to Thermostat BEFORE you remove it 5.