Install Instructions

PAGE 1
BACON INSTALLATIONS 1. Disconnect electrical power. 2. Remove inoperative control. 3. Select required dial shaft parts and prong drivers matching the original control to the replacement control. 4. Mount horizontal bracket to control using only 1/8” long mounting screws. Longer screws will protrude into the control and affect the control's operation. §. Move bracket forward or backwards until the proper shaft length has been attained. The two retaining screws should be tightened. Refer to Figure 1.
PAGE 2
11. Attach dial knob on replacement control, locating “off” position of dial the same as on the original. 12. Turn dial to normal position or mid-scale position. 13. Turn on electrical power and check the control's operation. Allow sufficient time for the unit to reach normal operating temperature. 14. Readjust the dial knob colder or warmer, as required. MOUNTING COLD CONTROLS WITH ORIGINAL MOUNTING BRACKET'S HARDWARE 1. Select required mounting bracket that matches the original. Figure 4. 2.