Operator’s Manual EH SERIES Gas Engine / Diesel Fired READ THIS MANUAL This manual contains important information for the use and safe operation of your RAMTEQ machine. FAILURE TO READ THIS MANUAL AND FOLLOW ITS INSTRUCTIONS PRIOR TO OPERATING OR ATTEMPTING ANY SERVICE OR MAINTENANCE PROCEDURE COULD RESULT IN SERIOUS INJURY OR DEATH TO YOU OR OTHER PERSONS; ALSO DAMAGE TO THE MACHINE OR TO OTHER PROPERTY.
Operator’s Manual Page Table of Contents Section 1 Operator’s Manual Unpacking....................................................................2 Safety Instructions and Warnings.............................3 Maintenance Instructions.......................................4, 5 Operating Instructions...............................................6 Section 2 Parts and Service Manual Exploded View..............................................................
Operator’s Manual Page Safety Guidelines � WARNING READ THIS FIRST! Failure to read and observe all WARNING statements could result in severe bodily injury or death, possible injury to other persons, damage to machine or other property. DO NOT operate this machine in areas where open flames are not permitted. DO NOT store or use combustible materials on or near this machine. Use this equipment only in well ventilated areas.
Operator’s Manual Page Maintenance Instructions MAINTENANCE PRECAUTIONS Do not permit acidic, caustic or abrasive fluids to be pumped through system. Periodically clean detergent inlet screen. This will ensure proper flow of water to the pump. High mineral content in water may adversely affect your machine and may require the use of a water softener to ensure proper operation. NEVER run the pump dry under any circumtances. Doing so will cause exteme damage to the pump.
Operator’s Manual Page Maintenance Instructions ELECTRODE SETTINGS Inspection of all wires, spring contacts and electrodes should be done periodically. Wayne Burner � WARNING Beckett Burner IF BLACK OR WHITE SMOKE VENTS FROM EXHAUST PORT UPON STARTING EQUIPMENT, DISCONTINUE USE AND ADJUST AIR BANDS BEFORE RESTARTING. OIL BURNER AIR BAND ADJUSTMENT RAMTEQ sets oil burners at sea level.
Operator’s Manual Page Operating Instructions LOCATION GUIDELINES Locate the machine on a solid and level surface so that engine and pump crankcase oil lubricate components properly. Avoid areas where water can build up in the working area. Possible injury can occur caused by the surface becoming slippery from water build up. Locate the machine in a well-ventilated area and away from flammable materials or fumes. Be sure ventilation warnings are observed.
Operator’s Manual Page Exploded View 27 28 25 23 34 26 32 33 31 24 30 29 11 8 10 17 16 12 13 18 9 14 35 4 15 8 19 2 3 7 5 36 37 45 22 6 20 21 39 46 40 45 41 42 43 RAMTEQ ® 44 14275 northwest freeway 38 1 Houston, TX 77040 phone: 713.983.6000 fax: 713.983.
Operator’s Manual Page Parts List Ref.# Part # Description Qty.
Operator’s Manual Page 12v Burner Assembly 20 19 18 21 17 22 15 14 16 13 10 11 12 1 2 3 4 5 6 9 8 7 Beckett Part # 21699UF 2140401 21405 31231U 5874BKU 5151501 3494 21807 218440ZU 21877U 21754U 3666 3493 5700 7492 51411 51776U 58020174 58020198 19 31802 20 7435U 21 51663 22 Ref.
Operator’s Manual Page 10 115V Burner Assembly 12 13 14 5 16 10 15 11 4 7 8 6 2 9 Beckett Ramteq Ref.
Operator’s Manual Page 11 5 Control Box Assemblies 6 4 7 Base Control Box 3 Ref.# Part # 1 2 3 4 5 6 7 180-00027-01 305-00038-01 571-00002-01 450-00004-01 457-00001-01 455-00002-01 455-00001-01 Description Qty. Control Box Label, Control Box Meter, Hour Switch, Toggle, NKK#S301F Boot, switch, water prrof, NKK#AT402 Relay,12V, VF441F11 Rectifier, GBPC2506 2 1 1 1 1 1 1 1 1 7 5 8 9 4 3 CH Upgrade Control Box 2 6 Ref.
Operator’s Manual Page 12 Engines & Mufflers Part # Description 206-00028-03 206-00004-01 206-00006-04 206-00023-01 207-00002-01 206-00017-02 207-00003-02 206-00029-01 207-00005-01 206-00011-01 207-00004-01 Engine, diesel, 10HP, Yanmar, L100V6CA1T1AA Engine, gas, 13HP, Honda, GX390U1QNR2 Engine, gas, 16HP, B&S, w/muffler installed Engine, gas, 18HP, B&S, 350447-1075-E1 Assy, muffler/shield, for B&S 16&20 Engine, gas, 20HP 20A, Honda, GX620U1QAF1 Assy, muffler/shield, Honda 16 &
Operator’s Manual Page 13 1 Belt Drive Pumps 2 General Pump TS2021-R Triplex Plunger Pump Pump Repair Parts Ref# 1. 2.
Operator’s Manual Page 14 Wiring Diagram ELECTRICAL SCHEMATIC “Small” Blk Wht Red Blower “Big” Red Ylw - N.O.
Operator’s Manual Page 15 Wiring Diagram ELECTRICAL SCHEMATIC EH W/ GENERATOR Pur Blk Burner Module Wht Fuel Solenoid Wht PRESSURE SWITCH Wht Blk Org Burner Mtr Wht Blk Wht HI-TEMPERATURE LIMIT SWITCH HOURMETER Grn BURNER SWITCH Blk Grn Blk Transformer Blk for Ignitor N.C. Small Control Box Wht Grn SMOOTH WIRE (Blk) RIBBED WIRE (Wht) 115v Rt Angle Plug RAMTEQ ® 14275 northwest freeway Houston, TX 77040 phone: 713.983.6000 fax: 713.983.
Operator’s Manual Page 16 From Coil 22 18 Down Stream Injection Plumbing 14 19 To Coil 15 14 From Pump 17 23 24 16 5 20 To Coil 13 21 16 8 7 5 1 1 7 9 12 11 6 Ref.
Operator’s Manual Page 17 From Coil 22 22 24 29 26 27 28 To Coil Up Stream Injection Plumbing 23 10 24 25 To Coil 10 From Pump 9 14 1 To Float Tank To Coil 13 To Float Tank 11 12 7 8 17 16 18 Ref.
Operator’s Manual Page 18 Flow Sensitive Unloader Plumbing From Coil To Coil 33 33 31 38 35 32 26 31 34 36 37 From Unloader To Coil To Coil 27 6 30 29 26 30 6 To Pump 25 From Pump 24 To Pump 20 17 From Pump 29 28 21 22 23 18 19 To Float Tank To Float Tank 16 16 1 17 15 14 2 17 13 4 12 5 11 6 10 RAMTEQ ® 9 8 7 3 14275 northwest freeway 3 4 11 12 Houston, TX 77040 phone: 713.983.6000 From Unloader 5 6 To Unloader fax: 713.983.
Operator’s Manual Page 19 Flow Sensitive Unloader Parts List Ref.
Operator’s Manual Page 20 troubleshooting problem Low Water Pressure cause action Insufficient water source Old or incorrect nozzle Plumbing or hose leak Obstruction in spray nozzle Chemical valve open Unloader valve worn Pump valves dir ty or worn Check hose size/water source Replace nozzle Tighten, repair or replace leak Clean or replace nozzle Close valve or submerge hose Replace unloader Clean or replace packing/valves No Chemical Flow Detergent valve closed Low detergent le
RAMTEQ Limited One Year WARRANTY Ramteq Incorporated ("RAMTEQ") warrants that the Product you have purchased from RAMTEQ or from an Authorized RAMTEQ Reseller is free from defects in materials or workmanship under normal use for a period of one (1) year from the date of purchase. This warranty extends only to you, the original Purchaser. It is not transferable to anyone who subsequently purchases the Products from you.
Ramteq Manufacturers Warranty Period Click on pictures to open manufacturers website. 5 years 5 years 3 years 3 years 3 years 3 years 18 months 18/36 months Ramteq Pressure Washers 14275 NORTHWEST FREEWAY HOUSTON, TX 77040 1 year PHONE: 713.983.6000 FAX: 713.983.
