Installation and Operation Manual

Page 18 WES
3
Installation and Operations Manual V1.4 Ramtech Electronics Limited 2018
The Settings menu can be accessed from the Main Menu by selecting
Settings with the directional pad then pressing Enter.
All settings are protected from unauthorised change by an access
code. By default, this is set to 1234.
Change Access Code
We recommend that you change the default 1234 access code to a
secure code specic to site.
To change the access code, navigate down the Settings Menu until the
Change Access Code option is highlighted as shown. Press Enter to
select.
The existing Access Code will then be requested, as shown below.
The new Access Code then needs to be entered twice.
Conrmation of the Access Code change will be displayed.
Unit Numbering
Every WES
3
unit is numbered when activated and rst paired to
the WES network. This unit number can be changed using the Unit
Numbering feature, and any number between 001 and 999 may be
used.
Units must be either freshly activated or already paired to a unit on the
same site as the Emergency Control Unit before renumbering.
To number a unit from a different site network, you will rst need to
deactivate and reactivate the site to remove the information specic to
the original site.
Select the number you wish to assign to a particular WES
3
unit using
the navigation pad. Once the correct number is displayed, press and
hold the A buttons on both the Emergency Control Unit and the unit
you are numbering. The amber LEDs on both units will illuminate and
then the green LEDs will ash to conrm successful renumbering.
To exit the Unit Numbering screen, press the left arrow when at the left
most digit of the unit number.
Settings
WES MAIN MENU
System Logs
Settings