Installation and Operation Manual
Page 13 WES
3
Installation and Operations Manual V1.4 Ramtech Electronics Limited 2018
After moving a unit, we recommend that you conduct a system test
to check that the movement has not adversely affected radio
communication. Ensure any site re plans are updated with any
revisions to WES
3
unit numbering and location.
Before shipping a unit or moving it to another site it must rst be
deactivated, in order to:
• prevent accidental triggering
• preserve battery unit life
• clear site information which would prevent it forming or joining
another site
First, remove the unit to be deactivated from the wall/ceiling and
ensure the back tamper button is not pressed in.
Hold down ‘A’ and then press ‘B’ three times in quick succession. All
three LEDs will briey illuminate and then switch off.
Note: units cannot be deactivated while an alarm is active.
Moving a Unit on Site
Removing a Unit from Site