Full Product Manual

① The nosecone and accessories. ②Place the hub with blades onto the rotor shaft ③ Fully tighten the nut to 500N.m

and “spin” it completely onto the turbine alternator shaft,

then place in sequence of flat washer, spring washer and nut.

④Snap the nosecone into position over the ⑤After installation tug on the nosecone to ⑥ Completed assembly.

outside edges of the blade hub and tighten by make sure it is securely attached and turn

screws to 7 N.m the blades to make sure it is not rubbing

against the front cover of the generator.