Full Product Manual

Install of The Compact Panel Cassette Type Indoor Unit

2.9 Install the panel

(1). Set the panel to the indoor unit body by matching the position of the swing ap motor of the

panel to the piping position of the panel to the piping position of the indoor unit as shown by g.13.

(2). Install the panel

① .

Install the panel on the indoor unit temporarily. When install, hang the latch on the hook

that is located on the opposite side of the swing ap on the panel of the indoor unit. (2

positions)

② .

Hang the remaining 2 latches to the hooks on the sides of the indoor unit.(Be careful not to

let the swing motor lead wire get caught in the sealing material.)

③ .

Screw the 4 hexagon head screws under the latches in about 0.59in (15mm). The panel

would rise.

④ .

Adjust the panel by turning it toward the direction pointed by the arrow as shown in g.13,

so that the adjust board connect the ceiling well.

⑤ .

Tighten the screws until the thickness of the sealing material between panel and indoor

unit reduced to 0.2-0.3in (5-8mm).

Fig.13

Notes:

① .

Improper screwing of the screws may cause the troubles shown in g.14.

Model

Power Supply

(V, Ph, Hz)

Min. Sectional Area of

Earth Wire(AWG)

Min. Sectional Area of

Power Cord(AWG)

CH24CC230VI 208~203V-1Ph-60Hz UL1015 AWG 18*1 UL1015 AWG 18*3