Instruction manual

LEDS1• 15
2 LEDS1s CHAINED TOGETHER
For even more flashing power you can buy 2 LEDS1s and make them flash at
the same time either in audio or stroboscope mode. The two kits are
connected via the external trigger jack. Connect them with the same double
ended 3.5mm cable described above. One LEDS1 is the “master” that drives
the other LEDS1, or the “slave”. Set the master to stroboscope or audio mode
and the slave to audio mode. The slave will now flash synchronously with the
master. The slave will also draw power from the master and run without a
power adapter of its own. This does load the master’s power adapter quite a
bit, and using two adapters is recommended for long term use.
CONCLUSION
We sincerely hope that you will enjoy the use of this Ramsey product. As
always, we have tried to compose our manual in the easiest, most “user
friendly” format that is possible. As our customers, we value your opinions,
comments, and additions that you would like to see in future publications.
Please submit comments or ideas to:
Ramsey Electronics Inc.
Attn. Hobby Kit Department
590 Fishers Station Drive
Victor, NY 14564
or email us at: [e-mail]
And once again, thanks from the folks at Ramsey!