Instruction manual

DDF1  30

labeled “ANT1” on the ANTINT board.

5. In the same way connect the wires connected to the DB9 connector

pins 2, 3, and 4 to the “ANT2”, “ANT3” and “ANT4” respectively.

6. Connect the wire from pin 5 on the DB9 connector to the “GND” pad

located near the “ANT4 IN” connection on the ANTINT board.

7. Verify that you have connected the control cable wires correctly. If

they are not connected properly your DDF1 will not indicate the right di-

rection of the elusive transmitter you are trying to find.

8. Connect the coax cables from the 4 antenna assemblies to the “ANT1

IN”, “ANT2 IN”, “ANT3 IN” and “ANT4 IN” connection points using the

same procedure in steps 4 through 8 on page 28.

Congratulations, You have finished the major assembly of your DDF1. All

that is left to do is some testing and then we’ll have you put it in the case and

weatherproof your antenna assembly. Don’t get impatient and jump ahead.

If there is a problem you may need to disassemble something if you go to the

final assembly now.

DB9 CONNECTOR (REAR VIEW)

4 3 2 1

8 9

KEPNUT

#4 INTER TOOTH

WASHER

FORMED

WIRE

NOTCH

PLASTIC

CAP

M4 SCREW

WHIP

ATENNA

ANTENNA ASSEMBLY DETAILS