Instruction manual

SM100 • 6
SM100 PARTS LIST
RESISTORS
 1 10 ohm [brown-black-black] (R1)
 1 75 ohm resistor [violet-green-black] (R14)
 3 470 ohm [yellow-violet-brown] (R5, 11, 15)
 5 1K ohm [brown-black-red] (R2, 3, 4, 7, 13)
 1 8.2K ohm [grey-red-red] (R8)
 1 10K ohm [brown-black-orange] (R 9)
 2 100K ohm resistors [brown-black-yellow] (R10, 12)
 1 1 megohm resistor [brown-black-green] (R16)
 1 5K ohm trimmer potentiometer [marked 502M] (R17)
 1 10K ohm PC mount potentiometer (R6)
CAPACITORS
 5 .01 uF disc capacitor [marked .01 or 103 or 10nF] (C3, 7, 12, 13, 14)
 4 .1 uF disc capacitor [marked .1 or 104] (C2, 6, 10, 11)
 3 10 uF electrolytic capacitors (C5, 8, 9)
 2 220 uF electrolytic capacitors (C1, 4)
INDUCTORS
 2 1800 uH inductors [green case marked 182] (L1, 2)
SEMICONDUCTORS AND INTEGRATED CIRCUITS
 1 1N4148 diodes [glass case with black band] (D5)
 2 1N4002 diode [epoxy case marked 1N4002] (D1, 2)
 1 12 volt zener diode [grey glass case marked 1N759A] (D7)
 1 27 volt zener diode [red glass case marked 971B] (D3)
 1 Varactor diode [looks like a transistor with only two leads marked
MVAM108] (D6)
 1 Light Emitting Diode [LED] (D4)
 4 NPN small signal transistor [marked 2N3904] (Q1, 2, 3, 4)
 1 FET [marked 2N5485 or MPF102] (Q5)
MISCELLANEOUS PARTS AND HARDWARE
 1 Sub-miniature power jack (J3)
 3 RCA type PC mount jacks (J1, 2, 4)
 1 DPDT pushbutton switch (S1)
 1 SM100A / SM100C printed circuit board
 1 7.5 inch ferrite rod
 1 11 feet of enameled magnet wire