Operating instructions

FAILURE TO FOLLOW
INSTRUCTIONS CAN
CAUSE INJURY TO THE
TOOL OPERATOR OR
TO BYSTANDERS.
• Usethetoolonlyinwellventilated
areas.
• Alwaysholdthetoolatrightangles
to the work surface.
• Neverattempttomakeafastening
at an angle to the work surface.
• Whilethetoolcanbeusedinany
position (floor, wall or ceiling) it is
important to have both the nose of
the tool and support foot in contact
with the work surface to minimize
spall and make the best quality
fastenings.
• Neverputyourhandoverthenose
end of the tool.
• Neverputyourhandonoroverthe
end of the tool to close the tool.
• Nevercarrythetoolwithyourfinger
on the trigger.
• Neverleavethetoolunattendedor
allow anyone to operate it without
first being trained.
• Neverengageinhorseplaywith
the tool.
• Alwayskeepthetoolpointedaway
from yourself or others.
• Neveroperatethetoolifexplosive
or flammable materials are nearby.
• Keepthetoolandsupplieslocked
up and out of the reach of children.
90°
The T2 tool may be used in
any position.
DANGER
SAFETY INSTRUCTIONS
SAFETY INSTRUCTIONS
DANGER 7
Keep tool locked up and
out of reach of children
Ceilings
Walls
Floors
Keep both the nose of the tool
and support foot in contact with
the work surface and hold tool
perpendicular to the work surface.