Operating instructions

Filters and Battery Contacts

Cleaning the filters and battery contacts on a regular

basis will help make your tool work more efficiently.

To clean the filters

• Remove the cover and the filters.

• Lightly tap the filters to remove any dust.

• Replace the filters if damaged.

• Replace the filters and the cover.

To clean the battery contacts

• Periodically wipe contacts with a dry, soft cloth.

• Should they show corrosion, clean with a piece of

very fine emery cloth and clean with a dry cloth.

TROUBLESHOOTING

Tool does not work

- LED light is off - No battery in tool - Install battery

- LED flashes red - Battery completely discharged - Charge battery

Fan is on but the

tool does not fire

- LED is red - Battery power is too low - Recharge battery

- LED is green - Fuel cell is exhausted - Put in new fuel cell

Fan stops after the - Call your local distributor for service

trigger is pulled

and LED is green

Tool firing is not - Fuel cell is exhausted - Put in a new fuel cell

consistent and

LED is green

Fasteners are not - Fuel cell is exhausted - Put in a new fuel cell

completely set - Filters are too dirty - Clean/replace filters

- Base material is too hard - Consult distributor

Tool makes - Consult your local distributor

low sound

- piston stays down

- no fastening made

- LED is green

Tool is sluggish and - Filters are too dirty - Clean/replace filters

overheats

SERVICING/TROUBLESHOOTING

FOR SERVICING REQUIRED BUT NOT LISTED IN THIS MANUAL,

PLEASE CONTACT YOUR LOCAL DISTRIBUTOR