Operating instructions

DESCRIPTION

The GypFast (G2) tool is a self-contained, fully

portable tool that uses liquid hydrocarbon fuel to

power a unique linear drive internal combustion

motor.

In order for you to fully understand the information

contained in this manual, you need a basic under-

standing of the tool. As you can see in the illustration

below, the GypFast (G2) tool is made up of three

assemblies: the Handle, the Motor, and the

Magazine.

As you examine the GypFast (G2) tool, become

familiar with the three major assemblies and the

various components located in each of them.

The Handle Assembly contains the Fuel Cell, the

Battery Voltage Indicator Light, Battery and the

Trigger.

The Motor Assembly contains the Cover and Filter,

the Motor Housing, the Nose, and the Safety Yoke.

The Magazine Assembly contains the Magazine,

Magazine Dow and Hinge Pin.

SPECIFICATIONS

Dimension: Height 16 inches

Length 13 inches

Weight: 7.9 pounds

Cycle Rate: Intermittent Operation 2 to 3 pins per

second. Continuous Operation 1000 pins per hour

NOTE: Exceeding these rates could cause the tool

to overheat, resulting in loss of performance or

damage to tool components.

By using the GypFast (G2) tool at its recommended

operation rate you will be able to drive several

thousand fasteners in a typical workday.

Maximum Fastener Length:

2-1/2 inch x 0.140 dia. shank

Magazine Capacity: 150 count coil.

Battery: 6 volts D.C.—Provides enough energy to

drive approximately 3000 fasteners on one charge.

Fuel Cell: Liquid hydrocarbon—Provides enough

fuel to drive up to 1000 fasteners.

AN OVERVIEW OF THE GypFast (G2) TOOL