Operating instructions

SYMPTOM POSSIBLE PROBLEMS SERVICE
Power/Exhaust Stage of Operation
Returning/Purging Stage of Operation
If the GypFast (G2) tool will not operate after following the above service directions,
return the tool to an Ramset Distributor Sales Representative for service.
800-241-5640
www.ramset.com
— Battery is discharged.
— Fuel Cell is low.
— There may be loss of seal
in combustion chamber.
— Fastener strip may be
binding.
— Jammed fastener.
— Fuel Cell is low.
— Spark Plug wire is loose.
— Filter element is dirty,
causing tool to overheat.
— Tool Sleeve or Steel Rings
are dirty.
— Tool operates properly,
but fasteners do not
drive fully.
— Tool operates, but no
fastener is driven.
— Tool operates erratically
or appears to be
losing power—tool
LED is green.
— Charge Battery.
— Check Fuel Cell according to Operating Manual
and replace as required.
— Press Safety Yokes against workpiece for one
minute. Pull trigger. If fastener does not drive,
there is a leak that requires service.
— Use only fasteners meeting Ramset specifications.
— Clear jam according to Operating Manual.
— Check Fuel Cell according to Operating Manual.
— Contact Ramset Distributor Sales Representative
for Service.
— Remove Filter element and clean according
to Operating Manual. Use safe cleaning solution
to remove stubborn debris.
— Clean tool per Cleaning Procedure.
TROUBLESHOOTING
16
TROUBLESHOOTING
— Tool operated and
drove fastener, but
piston did not return
to start position.
— Tool does not open
after tool cycles.
— Built-up dirt and debris on
Piston or in Nose bore.
— Mushrooming of Piston Tip.
— Exhaust ports on the
Sleeve are dirty or clogged.
— Tool (Sleeve) or Steel Rings
are dirty.
— Tool is dirty.
— Clean Piston and Nose bore with safety solvent.
— Contact Ramset Distributor Sales Representative
for service.
— Return tool to Authorized Ramset Distributor Sales
Representative for service.
— Contact Ramset Sales Representative for service
— Clean tool or replace Work Contacting Element
as required.