Operating instructions

PARTS LIST / MAINTENANCE

Always make sure the tool is not loaded before performing any service or repair and

always wear safety goggles when cleaning or servicing the tool.

NORMAL CLEANING

All front end parts shown in the disassembly section are to be cleaned daily with a good

detergent oil and wire brush. Remove all dirt and carbon buildup and wipe parts dry with

a clean rag. Check all parts for wear or damage before reassembly and replace or repair

any worn or damaged parts.

COMPLETE CLEANING / GENERAL MAINTENANCE

Heavy or constant exposure to dirt and debris may require that the tool be cleaned more

extensively. Complete disassembly and cleaning of all parts may be necessary to restore

the tool to normal operation. General maintenance should be performed every six months

or more often if the tool is subjected to heavy use. Contact your authorized Ramset

Distributor for assistance.

IMPROPERLY MAINTAINED TOOLS CAN CAUSE SERIOUS INJURIES

TO TOOL OPERATOR AND BYSTANDERS

CLEAN TOOL DAILY

ALWAYS FUNCTION TEST THE TOOL AFTER PERFORMING ANY

SERVICE. SEE PAGE 9 FOR DETAILS ON THE FUNCTION TEST.

MAINTENANCE

COBRA TOOL PARTS LIST

KEY PART NO. DESCRIPTION

1 SC301500 SPALL GUARD

2 SC301009 FRONT BARREL (BASEPLATE)

3 SC301011A SHEAR CLIP (PKG. OF 3)

4 SC301010 FASTENER GUIDE

5 SC301200A PISTON ASSEMBLY

6 SC301208 PISTON RING

7 SC302012 PAWL (STOP)

8 SC301006 REAR BARREL (PISTON SLEEVE)

9 SC301014A BARREL RETENTION ASSEMBLY

10 SC301016 PUSH PIN

11 SC301046A DETENT BALL ASSEMBLY

12 SC301034A TRIGGER ASSEMBLY AND PIN

13 SC301001 TOOL BODY

14 SC301113 BOLT (2)

15 SC301300A SEAR HOLDER ASSEMBLY

16 SC301531 SPRING, ADVANCE BAR

17 SC301400 FIRING PIN ASSEMBLY

18 SC301026A FIRING PIN SPRING ASSEMBLY

19 SC301600 HANDLE ASSEMBLY