Specifications

2. Shift the transmission into NEUTRAL.

3. While still rolling, rotate the transfer case control

switch to the desired position.

4. After the desired position indicator light is ON (not

flashing), shift the transmission back into gear.

Alternate Procedure

1. Bring the vehicle to complete stop.

2. With the ignition switch in the ON position and the

engine either OFF or running, shift the transmission into

NEUTRAL.

3. Rotate the transfer case control switch to the desired

position.

4. After the desired position indicator light is ON (not

flashing), shift the transmission back into gear.

NOTE:

•

If Steps 1 or 2 of either the Preferred or Alternate

Procedure are not satisfied prior to attempting the shift

or if they no longer are being met while the shift

attempt is in process, the desired position indicator

light will flash continuously while the original posi-

tion indicator light is ON, until all requirements have

been met.

•

The ignition switch must be in the ON position for a

shift to take place and for the position indicator lights

to be operable. If the ignition switch is not in the ON

position, then the shift will not take place and no

position indicator lights will be on or flashing.

STARTING AND OPERATING 427