Specifications

42
APPENDIX A
Separating PPC from POS
1. Loosen the (2) thumbscrews under the Panel POS (operator side) which secure the cover over the main
board IO connectors – remove cover.
2. Loosen the (2) thumbscrews under the pedestal which secure the (operator side) pedestal cover – remove
cover.
3. Loosen the (2) thumbscrews under the pedestal which secure the side panels of the pedestal – remove side
panels.
4. Loosen the (2) thumbscrews under the panel POS which secure the cable clamp which holds any peripheral
cables attached to the main board.
5. Loosen the (2) thumbscrews on the operator side of the pedestal which secure the cable clamp as in step 4
above.
6. Remove any peripheral IO cables attached to the main board IO ports.
7. Loosen the (2) thumbscrews under the pedestal which secure the (customer side) pedestal cover – remove
cover.
8. Loosen the thumbscrew on the pedestal side which secures the AC power cord to the power brick.
9. Disconnect AC power cord from the power brick.
10. Disconnect any cables to the IO board in the pedestal.
11. Loosen the thumbscrew on customer side of the pedestal which secures the power supply retaining bracket –
remove bracket.
12. Remove the power supply.
13. Using a Philips screwdriver – remove the (2) screws at the top of the Panel POS on the customer side which
secure the cover on the back side of the Panel POS – slide up and remove the back cover.
14. Disconnect the IO cable from the back side of the main board.
15. Disconnect the SATA cable from the back side of the main board.
16. Tilt the display assembly back and remove the (2) thumbscrews securing the Panel POS to the pedestal
mount.
17. Tilt the display forward – slide panel POS straight up to remove.
18. Install the replacement Panel POS back cover (customer side).