Installation guide

7
2. Configuration utility will scan for all wireless access
points automatically. Scan results will be displayed
here, please check if the wireless access point with
the SSID (the name of wireless access point) you
preferred is shown in Figure 4. If the wireless access
point you wish to connect does not show here,
please click Rescan to try again, until the one you
preferred is displayed. You may have to click Rescan
several times before you can see the access point
you wish to use. If you still can not see the wireless
access point after clicking Rescan more than five
times, move your computer closer to the location of
the wireless access point.
Figure 4