Installation guide

6
Connecting to Wireless Access Point
After the driver is correctly installed, the DP Wireless-N
PCI Adapter will try to connect to any unencrypted wireless
access point automatically. If you want to connect to a
specific wireless access point, or the access point you wish
to connect to uses encryption, you have to configure the
DP Wireless-N PCI Adapter and input required parameters,
to get connected. There are two ways you can configure
the DP Wireless-N PCI Adapter to connect to a wireless
access point: using the Ralink configuration utility which
comes with the included driver, and using built-in windows
zero configuration utility.
Using Ralink Utility
Please follow the instructions to use Ralink configuration
utility to connect to a wireless access point.
1. Right click the Ralink configuration utility icon
located at lower-right corner of computer desktop,
then click Launch Config Utilities, see Figure 3.
Figure 3